(2) Van De Wiele MPS Looms:
Building Year: 1988, 1989
Width: 2050 mm
3-Frame: 1344 pile threads/frame
Mirror Jacquard Harness – Electronic Takemura on Staubli head CR620
(1) Van De Wiele Loom:
Building Year: 2000
Width: 2300 mm
5-Frame: 1344 pile threads/frame
Open Jacquard Harness – Electronic Vande Wiele
(1) Cavitec Coating and Laminating Line:
The installation if very specific to handle heavier (even with pile) fabric or non wovens. The in and output is suitable for handling rolls with a pin or fork lift.
There are several guidance systems from Erhardt+Leimer. The transport trough the I.R. oven is effected on cooled rollers, temperature control in the 600 cm length I.R. oven. Manual cutting device, possible to control with video camera’s and PC.
(1) Rotating polishing unit with dust removing installation:
Building Year: 1997
Working Width: 2500 mm
Perfect Condition: only being used max. 1 shift
(1) Colsman & Kirschner – Fully Automatic Packing Machine:
Capable of wrapping 1, 2 or 3 rolls in one plastic bale. (Capacity in case of 3 rolls in a bale: 5 per min.)
Model FC
Building Year: 2002
Width: Roll of max. 30 cm diameter and min. 120
cm / max 260 cm
Condition: Used less than 1 shift per weak and
perfectly maintained
Following is the material handling flow:
1. Tilting the container with the rolls on a transportation belt.
2. Rolls are transported to the packing unit.
3. The packaging material is dispensed from a magazine, capable of holding 3 rolls of different width. It goes vertically downwards into the lower part of the machine and the packing table.
4. The rolls are pushed against the curtain of packaging material. During this process the packaging material almost fully envelops the roll.
5. There is a stationary welding bar between the receiver and the packaging table. The welding is always at the center of the rolls. The package will be dependably and tightly enveloped.
6. The rolls are then moved by an automated transport system into the appropriate position band the side ends are ultrasound welded.
7. The packed rolls get an self adhesive label with barcode on the outside, controlled by a P/C.
8. Finally the packed and labeled rolls are moved out of the machine and are lifted to be stored in one of the two dedicated containers.
This machine can be operated by one person, who has still free time for administrations or other jobs, while the machine is working = lower labor cost. There is very little loss of packing material = less material expenses. It has attractive consumer package for the rolls.
Rug finishing equipement:
(1) Matthis – Automatic length over-locking machine with supply transportation belt for big rolls:
Building Year: 1998
Width: 2400 mm
Includes left and right Titan machine
(2) Tanghe – Automatic width over-locking machines with automatic supply transport belts and cutting device and push off system + belt:
Building Year: 1998
Width: 2500 mm
Includes left and right Titan machine
(1) Evilo - Automatic width over-locking machine with cutting device and push off system + belt:
Building Year: 2002 (as good as new – almost not
used)
Width: 2500 mm
(1) Tanghe - Automatic width fringing machine with automatic transport belts including cutting device:
Includes left and right Titan machine
(1) Single Stand + Air-blow Tables:
15-Overlocking machines Brother, Wilkock,
Pegasus, Titan
5-Fringing machines Titan
5-Sewing machines (bout à bout) |
